TM 11-5841-283-12/NAVAIR 16-30APR39-1
4-5. CHECKING UNPACKED MATERIAL.
Inspect all 10 components of the radar signal detecting set for any damage that may have
resulted from shipment. Make sure the shipment is complete and that all components listed on the
packing slip are accounted for. If any damage or discrepancies are found, report them
Check the equipment for modifications. Modified equipment will have the MWO number on the front
panel, near the nomenclature plate. Check that all currently applicable MWO's have been applied.
Current MWO's applicable to the equipment are listed in DA Pam 310-1.
4-6. INITIAL INSTALLATION OF EQUIPMENT.
For the best possible performance of the radar signal detecting set, certain installation
requirements must be met The following information is to be used as a general guide.
NOTE
Wiring harnesses for the radar signal detecting set have been preinstalled on all
aircraft manufactured after fiscal year 1977. Therefore, installation locations for
the radar set components have been predetermined.
Wiring between radar signal detecting set components should not be run in a bundle with wiring
for other types of equipment. See paragraph 4-8 for required connections. For exact location of
system components, refer to aircraft TM.
4-4