TM 11-6625-214-12
specifies, by the listing of a "worktime" figure in the
specifies by code, those common tool sets (not indi-
appropriate subcolumn(s), the lowest level of mainte-
vidual tools) and special tools, test, and support
nance authorized to perform the function listed in col-
equipment required to perform the designated function.
umn 3. This figure represents the active time required to
perform that maintenance function at the indicated
C-4.
Tool and Test Equipment Requirements
category of maintenance. If the number or complexity of
(Table 1)
the tasks within the listed maintenance function vary at
a. Tool or Test Equipment Reference Code.
different maintenance categories, appropriate "worktime"
The numbers in this column coincide with the numbers
figures will be shown for each category. The number of
used in the tools and equipment column of the MAC. The
task-hours specified by the "worktime" figure represents
numbers indicate the applicable tool or test equipment
the average time required to restore an item (assembly,
for the maintenance functions.
subassembly, component, module, end item or system)
b. Maintenance Category. The codes in this
to a serviceable condition under typical field operating
column indicate the maintenance category allocated the
conditions.
This time includes preparation time,
tool or test equipment.
troubleshooting time and quality assurance/quality
c. Nomenclature. This column lists the noun
control time in addition to the time required to perform
name and nomenclature of the tools and test equipment
the specific tasks identified for the maintenance
re- quired to perform the maintenance functions.
functions authorized in the maintenance allocation chart.
d. National/NATO Stock Number.
This
Subcolumns of column 4 are as follows:
column lists the National/NATO stock number of the
C-Operator/Crew
specific tool or test equipment.
O-Organizational
e. Tool Number.
This column lists the
F-Direct Support
manufac- turer's part number of the tool followed by the
H-General Support
Federal Supply Code for Manufacturers (5digit) in
D-Depot
parentheses.
e. Column 5, Tools and Equipment. Column 5
C-2