INTRODUCTION
Explanation
Code
PE- Support equipment procured and stocked for
This manual lists repair parts and special tools
required for the performance of organizational
tenance repair activities.
maintenance of the SG-299/U, SG-299A/U, SG-
PF- Support equipment which will not be stocked
299B/U, and SG-299C/U. The PCCN for the equip-
but which will be centrally procured on
ment is GTEAAS for all models.
demand.
PG- Item procured and stocked to provide for
sustained support for the life of the equip-
ment. It is applied to an item peculiar to
This repair parts and special tools list is divided into
the equipment which because of probable
the following sections:
discontinuance or shutdown of production
a. Prescribed Load Allowance (PLA)-Section II.
facilities would prove uneconomical to
Not applicable.
reproduce at a later time.
KD- An item of depot overhaul/repair kit and not
parts authorized for the performance of maintenance
purchased separately. Depot kit difined as a
at the organizational level. This repair parts list is
kit that provides items required at the time
arranged in alphabetical order.
of overhaul or repair.
c. Special Tools, Test and Support Equip-
KF- An item of a maintenance kit and not pur-
ment-section IV. Not applicable.
chased separately. Maintenance kit defined
d. Index-Federal Stock Number and Reference
as a kit that provides an item that can be
Number Cross-Reference to Figure and Item Num-
replaced at organizational or direct support
levels of maintenance.
sequence, of all Federal stock numbers appearing in
KB- Item included in both a depot overhaul/repair
the listings, followed by a list, in alphameric
kit and a maintenance kit.
sequence, of all reference numbers appearing in the
MO- Item to be manufactured or fabricated at
listings. Federal stock number and reference num-
organizational level.
bers are cross-referenced to each illustration figure
MF- Item to be manufactured or fabricated at
and item number or reference designation ap-
direct support maintenance level.
pearance.
MH- Item to be manufactured or fabricated at
1-3. Explanation of
Columns
general support maintenance level.
The following provides an explanation of columns in
MD- Item to be manufactured or fabricated at
the tabular lists-
depot maintenance level.
a. Source, Maintenance, and Recoverability Codes
AO- Item to be assembled at organizational level.
(SMR).
A F - Item to be assembled at direct support main-
(1) Source code. Indicates the manner of
tenance level.
acquiring support items for maintenance, repair, or
AH- Item to be assembled at general support
overhaul of end items. Source codes are-
maintenance level.
A D - Item to be assembled at depot maintenance
Explanation
level.
Code
X A - Item is not procured or stocked because the
PA- Item procured and stocked for anticipated or
requirements for the item will result in the
known usage.
replacement of the next higher assembly.
PB- Item procured and stocked for insruance pur-
XB- Item is not procured or stocked. If not
poses because essentiality dictates that a
available through salvage, requisition.
minimum quantity be available in the sup-
XC- Installation drawing, diagram instruction
ply systems.
sheet, field service drawing, that is iden-
PC- Item procured and stocked and which other-
tified by manufacturer's part number.
wise would be coded PA except that it is
X D - Support items can be requisitioned with
deteriorative in nature.
PD- Support item, excluding support equipment,
procured for initial issue or outfitting and
NOTE
stocked only for subsequent or additional
Cannibalization or salvage may be used as
automatic replenishment.
a source of supply for any items source