TM 11-6625-3041-12/TO 33A1-8-908-1
SELF-TEST (cont)
2-4.
Step 576
Press RESET
q
4
Error
DISPLAY:
Detection
ERRORS display
must read O.
Press SINGLE ERROR
several times:
ERRORS display
must advance one
count each time SINGLE ERROR is pressed.
Disconnect cables from UNBALANCED DATA OUT and DATA IN and
TMG OUT and TMG IN.
Step .6-32
Set controls as
q
5
Data and
follows:
Timing
TIMING . . . . MASTER
DATA RATE . 0.6.
Use two BNC
adapters and BNC
cable to connect
DIPHASE OUT to
DIPHASE IN:
Green DATA IN and
TMG IN indicators
must light and BER
indicators must
blink. FAULT indi-
cator must not be
lit.
After 5 to 6 minutes,
BER indicators will stop blinking and GO indicator will light.
You need not wait for this, however, and may proceed immediately
to next step.
2-13