TM 11-6625-3041-12/TO 33A1-8-908-1
INTRODUCTION (cont)
SECTION I.
d. Column 4, Maintenance Category. This column specifies, by
the listing of a work time figure in the appropriate sub-
column(s), the category of maintenance authorized to perform
the function listed in column 3. This figure represents the
active time required to perform that maintenance function at
the indicated category of maintenance. If the number or
complexity of the tasks within the listed maintenance func-
tion vary at different maintenance categories, appropriate
work time figures will be shown for each category. The work
time figure represents the average time required to restore
an item (assembly, subassembly, component, module, end item,
or system) to a serviceable condition under typical field
operating conditions. This time includes preparation time
(including any necessary disassembly/assembly time), trouble-
shooting/fault location time, and quality assurance/quality
control time in addition to the time required to perform the
specific tasks identified for the maintenance functions
authorized in the maintenance allocation chart. The symbol
designations for the various maintenance categories are as
follows:
Operator or Crew
C
O
Organizational Maintenance
Direct Support Maintenance
F
General Support Maintenance
H
D
Depot Maintenance
e. Column 5, Tools and Equipment. This column specifies, by
code, those common tool sets (not individual tools) and
special tools, TMDE, and support equipment required to per-
form the designated function.
f. Column 6, Remarks. This column shall, when applicable, con-
tain a letter code, in alphabetic order, which shall be keyed
to the remarks contained in Section IV.
Explanation a. Column 1, Reference Code. The tool and test equipment code
B-4
correlates with a code used in the MAC, Section II, column 5.
of Columns
in Tool and
Test Equip- b. Column 2, Maintenance Category. The lowest category of
maintenance authorized to use the tool or test equipment.
ment
Requirements,
Section III c. Column 3, Nomenclature. Name or identification of the tool
or test equipment.
d. Column 4, National Stock Number. The National stock number
of the tool or test equipment.
The manufacturer's part number.
e. Column 5, Tool Number.
B-3