TM 11-6625-3041-30P
TO 33A1-8-908-14
SECTION I
INTRODUCTION
1. Scope
because of probable discontinuance or shut-
down of production facilities, would prove un-
This manual lists spares and repair parts; special tools;
economical to reproduce at a later time.
special test, measurement, and diagnostic equipment
Code
Definition
(TMDE), and other special support equipment required for
XA -- Item is not procured or stocked because the re-
performance of direct support maintenance of the SG-
quirements for the item will result in the
1139( )/G. It authorizes the requisitioning and issue of
replacement of the next higher assembly.
spares and repair parts as indicated by the source and
XB -- Item is not procured or stocked. If not available
maintenance codes.
through salvage, requisition.
2. General
NOTE
This Repair Parts and Special Tools List is divided into the
Cannibalization or salvage may be used as a
following sections:
source of supply for any items source coded
a. Section II. Repair Parts List. A list of spares and repair
above except those coded XA and aircraft
parts authorized for use in the performance of mainten-
support items as restricted by AR 750.1.
ance. The list also includes parts which must be removed
(2) Maintenance code. Maintenance codes are as-
for replacement of the authorized parts. Parts lists are
signed to indicate the levels of maintenance authorized to
composed of functional groups in numeric sequence, with
USE and REPAIR support items. The maintenance codes
the parts in each group listed in figure and item number
are entered in the third and fourth positions of the Uniform
sequence.
SMR Code as follows:
b. Section III. Special Tools List. Not applicable.
(a) The maintenance code entered in the third
c. Section IV. National Stock Number and Part Number
position will indicate the lowest maintenance level
Index. A list, in National item identification number (NIIN)
authorized to remove, replace, and use the support item.
sequence, of all National stock numbers (NSN) appearing
The maintenance code entered in the third position will
in the listings, followed by a list, in alphameric sequence,
indicate one of the following levels of maintenance:
of all parts numbers appearing in the listings. National
Application/Explanation
stocks numbers and part numbers are cross-referenced to
Code
O Support item is removed, replaced, used at the
each illustration figure and item number appearance.
organizational level.
3. Explanation of Columns
F Support item is removed, replaced, used at the
a. Illustration. This column is divided as follows:
direct support level.
(1) Figure number. Indicates the figure number of the
D Support items that are removed, replaced, used at
illustration on which the item is shown.
depot, mobile depot, specialized repair actively
(2) Item number. The number used to identify item
only.
called out in the illustration.
(b) The maintenance code entered in the fourth
b. Source, Maintenance, and Recoverability (SMR) Codes.
position indicates whether the item is to be repaired and
(1) Source code. Source codes indicate the manner of
identifies the lowest maintenance level with the capability
acquiring support items for maintenance, repair, or
to perform complete repair (i.e., all authorized mainten-
overhaul of end items. Source codes are entered in the first
ance functions). This position will contain one of the
and second positions of the Uniform SMR Code format as
following maintenance codes:
follows:
Code
Application/Explanation
H The lowest maintenance level capable of com-
Code
Definition
PA -- Item procured and stocked for anticipated or known
plete repair of the support item is the general
usage.
support level.
PG -- Item procured and stocked to provide for sustained
D The lowest maintenance level capable of complete
support for the life of the equipment. It is applied
repair of the support item is the depot level.
to an item peculiar to the equipment which,
Z Nonreparable. No repair is authorized.
1