TM 11-6625-3051-12
Modulation Modes:
Internal Modulation:
Main generator output modulated by sine, triangle, or square
Amplitude Modulation:
waves.
Main generator output modulated by positive and negative
ramps used as sweep voltages.
Main generator output modulated by sine, triangle, or square
Phase Modulation:
waves. Amplitude of modulating signal shifts phase of main
generator output 50
External Modulation:
Main generator output modulated by sine, triangle, or square
Amplitude Modulation:
waves from EXT MOD IN front panel connector.
Main generator output modulated by changes in voltage
levels at FM IN front panel connector.
Main generator output modulated by sine, triangle, or square
Phase Modulation:
waves from EXT MOD IN front panel connector. Amplitude
of modulating signal shifts phase of main generator output
50.
Selectable from 0.0002 Hz to 20 MHz in 10 overlapping
Frequency Range:
ranges. VERNIER control varies frequency approximately
1% in any range.
Selectable sine, triangle, and square waves variable to
Function Outputs:
15 Vp-p into 50Ω. Selectable positive and negative pulses
variable to 7.5 V peak into 50Ω. All waveforms and dc can
supply up to 150 mA current output.
Sine and triangle waveform start/stop point trigger range
Start/Stop Range:
approximately 90 up to 2 MHz.
Front panel selectable. DC offset plus signal adjustable to
DC Offset/Output:
more positive than + 7.5 V and more negative than 7.5 V
into 50Ω. DC output adjustable to more positive than + 7.2 V
and more negative than 7.2 V into 50Ω.
External Modulation Input:
AM:
Sensitivity of 1 volt input to provide 3 volts of modulation.
Sensitivity of 1 volt input to sweep 20% of selected fre-
FM:
Sensitivity of 1 volt input for 10 of phase shift. Input
PM:
impedance is 50 κΩ.
1-5