TM 11-6625-3051-12
APPENDIX B
MAINTENANCE ALLOCATION CHART (MAC)
Section I. INTRODUCTION
B-1 . GENERAL.
This appendix provides a summary of maintenance operations for Signal Generator SG-1171/U. It authorizes
categories of maintenance for specific maintenance functions or repairable items and components, and the tools
and equipment to perform each function. This appendix may be used as an aid in planning maintenance operations.
B-2. MAINTENANCE FUNCTION.
Maintenance functions will be limited to and defined as follows:
Inspect. To determine the serviceability of an item by comparing its physical, mechanical, and/or
a.
electrical characteristics with established standards through examination.
Test. To verify serviceability and to detect incipient failure by measuring the mechanical or electrical
b.
characteristics of an item and comparing those characteristics with prescribed standards.
c. Service. Operations required periodically to keep an item in proper operating condition, i.e., to clean
(decontaminate), to preserve, to drain, to paint, or to replenish fuel, lubricants, hydraulic fluid, or compressed
air supplies.
d. Adjust. To maintain, within prescribed limits, by bringing into proper or exact position, or by setting
the operating characteristics to the specified parameters.
e.
Align. To adjust specified variable elements of an item to bring about optimum or desired performance.
f.
Operate. To determine and cause corrections to be made or to be adjusted on instruments or test,
measuring, and diagnostic equipments used in precision measurement. Consists of comparisons of two instruments,
one of which is a certified standard of known accuracy, to detect and adjust any discrepancy in the accuracy
of the instrument being compared.
Install. The act of emplacing, seating, or fixing into position an item, part, module (component or
g.
assembly) in a manner to allow the proper functioning of the equipment or system.
h.
Replace. The act of substituting a serviceable like type part, subassembly, or module (component or
assembly) for an unserviceable counterpart.
i.
Repair. The application of maintenance services (inspect, test, service, adjust, align, calibrate, replace)
or other maintenance actions (welding, grinding, revetting, straightening, facing, remachining, or resurfacing) to
restore serviceability to an item by correcting specific damage, fault, malfunction, or failure in a part, subassembly,
module (component or assembly), end item, or system.
Overhaul. That maintenance effort (service/action), necessary to restore an item to a completely
j.
serviceable/operational condition as prescribed by maintenance standards (i.e., DMWR) in appropriate technical
publications. Overhaul is normally the highest degree of maintenance performed by the Army. Overhaul does not
normally return an item to like-new condition.
B-1