TM 11-6625-575-24P
SECTION I
INTRODUCTION
Code
Definition
1.
Scope
PA - Item procured and stocked for anticipated or
known usage.
This manual lists spares and repair parts; special tools;
special test, measurement, and diagnostic equipment
XD - A support item that is not stocked.
When
(TMDE), and other special support equipment required
required, item will be procured through normal
for performance of organizational, direct support, and
supply channels.
general support maintenance of the TS-452/U.
It
authorizes the requisitioning and issue of spares and
NOTE
repair parts as indicated by the source and maintenance
codes.
Cannibalization or salvage may be used as a
source of supply for any items source coded
above except those coded XA and aircraft
2.
General
support items as restricted by AR 700-42.
Maintenance code.
Maintenance
(2)
This Repair Parts and Special Tools List is divided into
codes are assigned to indicate the levels of maintenance
the following sections:
authorized to USE and REPAIR support items. The
a.
maintenance codes are entered in the third and fourth
spares and repair parts authorized for use in the
positions of the Uniform SMR Code format as follows:
performance of maintenance. The list also includes
(a)
The
maintenance
code
parts which must be removed for replacement of the
netered in the third position will indicate the lowest
authorized parts. Parts lists are composed of functional
maintenance level authorized to remove, replace, and
groups in numeric sequence, with the parts in each
use the support item. The maintenance code entered in
group listed in figure and item number sequence.
the third position will indicate one of the following levels
b.
Section III.
Special Tools List.
Not
of maintenance:
applicable.
c.
Code
Application/Explanation
Part Number Index. A list, in National item identification
number (NIIN) sequence, of all National stock numbers
O-
Support item is removed, replaced, used at the
(NSN) appearing in the listings, followed by a list, in
organizational level.
alphameric sequence, of all part numbers are cross-
H-
Support item is removed, replaced, used at the
referenced to each illustration figure and item number
general support level.
appearance.
(b)
The
maintenance
code
entered in the fourth position indicates whether the item
3.
Explanation of Columns
is to be repaired and identifies the lowest maintenance
level with the capability to perform complete repair (i.e.,
a.
Illustration.
This column is divided as
all authorized maintenance functions). This position will
follows:
contain one of the following maintenance codes:
Figure number. Indicates the figure
(1)
number of the illustration on which the item is shown.
Code
Application/Explanation
Item number. The number used to
(2)
identify item called out in the illustration.
H-
The lowest maintenance level capable of complete
b.
Source, Maintenance, and Recoverability
repair of the support item is the general support
(SMR) Codes.
level.
Source code. Source codes indicate
(1)
Z-
Nonreparable. No repair is authorized.
the manner of acquiring support items for maintenance,
Recoverability code. Recoverability
(3)
repair, or overhaul of end items. Source codes are
codes are assigned to support items to indicate the
entered in the first and second positions of the Uniform
disposition action on unserviceable items.
The
SMR Code format as follows:
recoverability code is entered in the fifth position of the
Uniform SMR Code format as follows:
1