TM 11-6625-586-24P
quantity of the item used in the breakout shown on
Recoverability
Definition
codes
the illustration figure, which is prepared for a
ZNonreparable item. When unserviceable, con-
functional group, subfunctional group, or an
demn and dispose at the level indicated in
assembly.
position 3.
4. Special Information
HReparable item. When uneconomically
The following publications pertain to the
reparable, condemn and dispose at the
AN/URM-103 and its components:
general support level.
DReparable item. When beyond lower level repair
AN/URM-103
capability, return to depot. Condemnation
and disposal not authorized below depot level.
AN/URM-l03
c. National Stock Number. Indicates the National
5. How to Locate Repair Parts
stock number assigned to the item and will be used
for requisitioning purposes.
a. When National stock number or part number is
unknown.
d. Part Number. Indicates the primary number
used by the manufacturer (individual, company,
(1) First. Using the table of contents, deter-
firm, corporation, or Government activity), which
mine the functional group within which the item
belongs. This is necessary since illustrations are
controls the design and characteristics of the item by
means of its engineering drawings, specifications,
prepared for functional groups and listings are
divided into the same groups.
standards, and inspection requirements to identify
an item or range of items.
(2) Second. Find the illustration covering the
NOTE
functional group to which the item belongs.
When a stock numbered item is
(3) Third. Identify the item on the illustration
requisitioned, the repair part received may
and note the illustration figure and item number of
have a different part number than the part
the item.
being replaced.
(4) Fourth. Using the Repair Parts Listing,
e. Federal Supply Code for Manufacturer
find the figure and item number noted on the
(FSCM). The FSCM is a 5-digit numeric code listed
illustration.
in SB 708-42 which is used to identify the
b. When National stock number or part number is
manufacturer, distributor, or Government agency,
known.
etc.
(1) First. Using the Index of National Stock
f. Description. Indicates the Federal item name
Numbers and Part Numbers, find the pertinent
and, if required, a minimum description to identify
National stock number or part number. This index is
the item.
in NIIN sequence followed by a list of part numbers
g. Unit of Measure (U/M). Indicates the standard
in alphameric sequence, cross-referenced to tie
of the basic quantity of the listed item as used in
illustration figure number and item number.
performing the actual maintenance function. This
(2) Second. After finding the figure and item
measure is expressed by a two-character alphabetical
number, locate the figure and item number in the
abbreviation (e.g., ea, in, pr, etc.). When the unit of
repair parts list.
measure differs from the unit of issue, the lowest
6. Abbreviations
unit of issue that will satisfy the required units of
Not applicable.
measure will be requisitioned.
h. Quantity Incorporated in Unit. Indicates the
(Next printed page is 4)
2