TM 9-6625-1969-34P
H-
Reparable item. When uneconomically reparable,
e. Federal Supply Code for Manufacturer (FSCM).
condemn and dispose at the general support level.
The FSCM is a 5-digit numeric code listed in SB 708-42
which is used to identify the manufacturer, distributor, or
D-
Reparable item. When b yond lower level repair
e
Government agency, etc.
capability, return to depot. Condemnation and
disposal not authorized below depot level.
f. Description. Indicates the Federal item name
and, if required, a minimum description to identify the
L-
Reparable item.
Repair, condemnation, and
item. The physical security classification of the item is
disposal not authorized below depot/ specialized
indicated by the parenthetical entry (insert applicable
repair activity level.
physical security classification abbreviation, e.g., Phy
Sec C1 (C) -Confidential, Phy Sec C1 (S) Secret, Phy
A-
Item requires special handling or condemnation
Sec C1(T) -Top Secret). Items that are included in kits
procedures because of specific reasons (i.e.,
and sets are listed below the name of the kit or set with
precious metal content, high dollar value, critical
the quantity of each item in the kit or set indicated in the
material or hazardous material).
Refer to
quantity incorporated in unit column. When the part to
appropriate manuals/ directives for specific
be used differs between serial numbers of the same
instructions.
model, the effective serial numbers are shown as the
last line of the description. In the Special Tools List, the
c. National Stock Number (NSN). Indicates the
initial basis of issue (BOD appears as the last line in the
NSN assigned to the item and which will be used for
entry for each special tool, special Test, Measurement,
requisitioning.
and Diagnostic Equipment (TMDE), and other special
support equipment.
When density of equipments
d. Part Number. Indicates the primary number
supported exceeds density spread indicated in the BOI,
used by the manufacturer (individual, company, firm,
the total authorization is increased accordingly.
corporation, or Government activity), which controls the
design and characteristics of the item by means of its
g. Unit of Measure (U/M). Indicates the standard
engineering drawings, specifications, standards, and
of the basic quantity of the listed item as used in
inspection requirements to identify an item or range of
performing the actual maintenance function.
This
items.
measure is expressed by a two-character alphabetical
abbreviation (e.g., ea, in, pr, etc). When the unit of
NOTE
measure differs from the unit of issue, the lowest unit of
issue that will satisfy the required units of measure will
When a stock numbered item is
be requisitioned.
requisitioned, the item received may
have a different part number than the
part being replaced.
4