H-
Reparable item.
When uneconomically
reparable, condemn and dispose at the general
e. Federal Supply Code for Manufacturer
support level.
(FSCM). The FSCM is a 5-digit numeric code listed in
SB 708-42 which is used to identify the manufacturer,
D-
Reparable item. When beyond lower level repair
distributor, or Government agency, etc.
capability, return to depot. Condemnation and
disposal not authorized below depot level.
f.
Description. Indicates the Federal item name
and, if required, a minimum description to identify the
L-
Reparable item. Repair, condemnation, and
item. The physical security classification of the item is
disposal not authorized below depot/ specialized
indicated by the parenthetical entry (insert applicable
repair activity level.
physical security classification abbreviation, e.g., Phy
Sec Cl (C)-Confidential, Phy Sec Cl (S)-Secret, Phy Sec
A-
Item requires special handling or condemnation
Cl (T)-Top Secret). Items that are included in kits and
procedures because of specific reasons (i.e.,
sets are listed below the name of the kit or set with the
precious metal content, high dollar value,
quantity of each item in the kit or set indicated in the
critical material or hazardous material). Refer to
quantity incorporated in unit column. When the part to be
appropriate manuals/ directives for specific
used differs between serial numbers of the same model,
instructions.
the effective serial numbers are shown as the last line
of the description. In the Special Tools List, the initial
c. National Stock Number(NSN). Indicates the
basis of issue (BOI) appears as the last line in the entry
NSN assigned to the item and which will be used for
for each special tool, special Test, Measurement, and
requisitioning.
Diagnostic Equipment (TMDE), and other special support
equipment. When density of equipment's supported
d. Part Number. Indicates the primary number
exceeds density spread indicated in the BOI, the total
used by the manufacturer(individual, company, firm,
authorization is increased accordingly.
corporation, or Government activity), which controls the
design and characteristics of the item by means of its
g. Unit of Measure (U/M).
Indicates the
engineering drawings, specifications, standards, and
standard of the basic quantity of the listed item as used
inspection requirements to identify an item or range of
in performing the actual maintenance function. This
items.
measure is expressed by a two character alphabetically
abbreviation (e.g., e a, in, pr, etc). When the unit of
measure differs from the unit of issue, the lowest unit of
NOTE
issue that will satisfy the required units of measure will
be requisitioned.
When a stock numbered item is requisitioned,
the item received may have a different part
number than the part being replaced.
4