TM 11-6625-2948-14&P
f. Column 6, Remarks. Not applicable.
quired to perform that maintenance function at the
indicated category of maintenance. If the number or
D-4. Tool and Test Equipment Requirements
complexity of the tasks within the listed maintenance
function vary at different maintenance categories, ap-
(Sec III)
propriate "work time" figures will be shown for each
a. Tool or Test Equipment Reference Code. T h e
category, The number of task-hours specified by the
numbers in this column coincide with the numbers used
"work time" figure represents the average time required
in the tools and equipment column of the MAC. The
to restore an item (assembly, subassembly, component,
numbers indicate the applicable tool or test equipment
module, end item or system) to a serviceable condition
for the maintenance functions.
under typical field operating conditions. This time in-
b. Maintenance Category. The codes in this column
cludes preparation time, troubleshooting time, and
indicate the maintenance category allocated the tool or
quality assurance/quality control time in addition to the
test equipment.
time required to perform the specific tasks identified
c. Nomenclature. This column lists the noun name
for the maintenance functions authorized in the main-
and nomenclature of the tools and test equipment re-
tenance allocation chart. Subcolumns of column 4 are
quired to perform the maintenance functions.
as follows:
d. National/NATO Stock Number. This column lists
Operator/Crew
C--
the National/NATO stock number of the specific tool
O -- Organizational
or test equipment.
F--
Direct Support
e. Tool Number. This column lists the manufactur-
General Support
H--
er's part number of the tool followed by the Federal
D--
Depot
Supply Code for manufacturers (5-digit) in parentheses.
e. Column 5, Tools and Equipment. Column 5 speci-
fies by code, those common tool sets (not individual
D-5. Remarks (See IV)
tools) and special tools, test, and support equipment
Not applicable.
required to perform the designated function.
D-2