TM 11-6625-3025-14/ET426-AA-MMA-010/E154 VII210/T.O. 33A1-8-902-1-1
Section II. INSTALLATION
2-3.
Introduction. The test pattern generator is a portable, self-contained instrument which does not require
permanent installation. The unit is ready for installation after unpacking as described in paragraph 2-1. No special tools
are required for installation.
2-4.
Electrical Interconnection. Perform electrical interconnection as follows:
a. Refer to figures 2-1 and 2-2 and connect the test pattern generator as shown in a typical installation test set-
up for a television display device.
b.
Check that ac power switch on test pattern generator is in the OFF position.
c.
Connect ac power cable of test pattern generator to a 115 VAC, 50-400 Hz power source.
NOTE
Since an internal sync generator is used, no inputs are required and the rear panel
connectors can serve as auxiliary sync outputs for external use. If pulse signals
are not used elsewhere, terminations (75 ohms) should be installed on each output
to permit all signals to be at the proper levels and characteristic impedance.
d.
Perform the operating instructions described in Chapter 3.
2-2
