TM 11-6625-3025-14/ET426-AA-MMA-010/E154 VII210/T.O. 33A1-8-902-1-1
b.
Replacement. Replace printed circuit board connector as follows:
(1) Secure connector to frame assembly with two screws, lockwashers and nuts.
(2) Solder leads to connector.
(3) Install printed circuit card (paragraph 6-9b).
(4) Secure top and bottom panels.
6-32. Printed Circuit Card Guide Removal and Replacement.
Perform the following procedure to remove and
replace card guide.
a.
Removal. Remove card guide as follows:
(1) Remove eight screws securing top panel.
(2) Remove printed circuit card (paragraph 6-9a).
(3) Insert the blade of a small flat screwdriver behind the plastic card guide and snap out card guide.
b.
Replacement. Replace card guide as follows:
(1) Insert card guide in holes in card frame and push in.
(2) Install printed circuit card (paragraph 6-9b).
(3) Secure top panel with eight screws,
6-20
