TM 11-6625-3041-20P
SECTION I
INTRODUCTION
Definition
Code
1. Scope
PA Item procured and stocked for anticipated or
This manual lists spares and repair parts, special tools;
known usage.
special test, measurement, and diagnostic equipment
XB Item is not procured or stocked. If not avail-
(TMDE), and other special support equipment required for
able through salvage, requisition.
performance of organizational maintenance of the SG-
NOTE
1139( )/G. It authorizes the requisitioning and issue of
Cannibalization or salvage may be used as a
spares and repair parts as indicated by the source and
source of supply for any items source coded
maintenance codes.
above except those coded XA and aircraft
2. General
support items as restricted by AR 750-1.
This Repair Parts and Special Tools List is divided into the
(2) Maintenance code. Maintenance codes are as-
following sections:
signed to indicate the levels of maintenance authorized to
a. Section II. Repair Parts List. A Iist of spares and
USE and REPAIR support items. The maintenance codes
repair parts authorized for use in the performance of
are entered in the third and fourth positions of the Uniform
maintenance. The list also includes parts which must be
SMR Code format as follows:
removed for replacement of the authorized parts. Parts
(a) The maintenance code entered in the third
lists are composed of functional groups in numeric
position will indicate the lowest maintenance level
sequence, with the parts in each group Iisted in figure and
authorized to remove, replace, and use the support item.
item number sequence.
The maintenance code entered in the third position will
b. Section III. Special Tools List. Nonapplicable.
indicate one of the following levels of maintenance:
c. Section IV. National Stock Number and Part Number
Application/Exp/anation
Code
Index. A list, in National item identification number (NIIN)
O Support item is removed, replaced, used at the
sequence, of all National stock numbers (NSN) appearing
organizational level.
in the listings, followed by a list, in alphanumeric sequence,
(b) The maintenance code entered in the fourth
of all part numbers appearing in the listings. National
position indicates whether the item is to be repaired and
identifies the lowest maintenance level with the capability
stock numbers and part numbers are cross-referenced to
each illustration figure and item number appearance.
to perform complete repair (i.e., all authorized mainte-
nance functions). This position will contain one of the
3. Explanation of Columns
following maintenance codes:
Code
Application/Explanation
a. Illustration. This column is divided as follows:
H The lowest maintenance level capable of complete
(1) Figure number. indicates the figure number of the
repair of the support item is the general support
illustration on which the item is shown.
level.
(2) Item number. The number used to identify item
D The lowest maintenance level capable of complete
called out in the illustration.
repair of the support item is the depot level.
b. Source, Maintenance, and Recoverability (SMR)
Z Nonreparable. No repair is authorized.
Codes.
(3) Recoverability code. Recoverability codes are
(1) Source code. Source codes indicate the manner of
assigned to support items to indicate the disposition
acquiring support items for maintenance, repair, or
action on unserviceable items. The recoverability code is
overhaul of end items. Source codes are entered in the first
entered in the fifth position of the Uniform SMR Code
and second positions of the Uniform SMR Code format as
format as follows:
follows:
1
