TM 32-6625-022-24&P
0 dB to 70 dB in 10 dB
RF output voltage
Attenuation . . . . . . . . . . .
steps, 2 dB, at any design
variation (UHF) . . . . . . . . Not more than 0.5 dB at
frequency. RF output con-
maximum sweep width.
trol provides a vernier over a
Spurious beats and
10 dB range.
harmonics . . . . . . . . . . . . At least 25 dB below the
Internal detector
fundamental frequency.
No greater than 1.2 at any
VSW-R . . . . . . . . . . . . .
Source impedance . . . . . . . . Operates into a 50 ohm load
design frequency when ter-
(nominal).
minated in a 50 ohm load.
Source VSWR . . . . . . . . . . Not greater than 1.5 when
Internal detector
properly terminated at any
At least 75 percent at any
efficiency . . . . . . . . . . .
design frequency.
design frequency.
Sweep linearity . . . . . . . . . Within 5 percent of the
Internal detector frequency
sweep width.
response . . . . . . . . . . . . . Within 0.5 dB on the VHF
Sweep rate (line) . . . . . . . . At the power line frequency.
range and within 1 dB on
Sweep rate (variable) . . . . . . Continuously variable from
the UHF range.
5 to 60 Hz.
Power consumption . . . . . . Approximately 33 watts.
Sweep rate (manual) . . . . . . Manaul control of sweep
Input power . . . . . . . . . . . 115 11.5 Vat, single phase,
rate.
60 10 Hz or 400 20 Hz.
Horizontal output
Overall dimensions . . . . . . . 12-1/2 inches high.
voyage. . . . . . . . . . . . . . Variable from 0 to 18 volts
22 inches wide.
peak-to-peak, 1.8 Vdc, at
18-1/2 inches deep.
either extreme and at the
Weight . . . . . . . . . . . . . . . Approximately 51 pounds.
sweep frequency.
Cubage . . . . . . . . . . . . . . . Approximately 2.95 cubic
Frquency dial accuracy . . . 1 dial division (10 MHz).
feet.
RF output meter
+200 Vdc regulation . . . . . . Within 1.2 volts. (90-140
accuracy . . . . . . . . . . . . . 3 percent.
Vac)
+30 -30 Vdc regulation . . . . Within 0.001 volt. (90-
Internal frequency
140 Vac)
marker accuracy . . . . . . . . 0.01 percent at 1 MHz.
1-3/(1-4 Blank)
