h. Quantity Incorporated in Unit. Indicates the
quantity of the item used in the breakout shown on the
NOTE
illustration figure, which is prepared for a functional
Repair parts should not be requisitioned for plug-
group, subfunctional group, or an assembly
A "V'
in boards identified in the plug-in board
appearing in this column in lieu of quantity indicates that
exchange program, except by the depot
no specific quantity is applicable (e.g., shims, spacers,
designated to perform the repair. Repair of
etc).
calibration set components, with plug-in board
assemblies or subassemblies designated as
4.
Special Information
program exchange replacements with a
recoverability code of L, will be accomplished by
replacing the plug-in board.
a. Repair parts for components of standards
sets which can be identified as existing in the supply
c. The plug-in board exchange program
system will be requisitioned through normal supply
functions are as follows:
channels from the appropriate supply commodity
manager.
(1) Requisitioning instructions for initial
issue plug-in boards will be provided since new
b. Repair parts for components of standard
instrument boards are included in the program.
assets which cannot be identified as to proper supply
source will be requisitioned from USAMICOM, using
(2) As a plug-in board covered by the
routing identifier B64 and furnishing as a minimum, the
program fails, a replacement will be requisitioned.
following as exception data.
Requisitions will be submitted to Commander, US Army
Missile Command, B64, Redstone Arsenal, AL 35809.
(1). Component stock
number
of
the
individual end item to be repaired.
(3) Simultaneously with c(2) above, the
defective board being replaced will be shipped by
(2). Component manufacturer's equipment
certified mail, return receipt requested, to the following
model number and serial number.
address:
(3) The equipment manufacturer's stock
Transportation Officer
number as listed in the appropriate manual for the
Anniston Army Depot
desired repair part.
M/F Field Service Stock
Anniston, AL 36201
(4). The repair part reference designation,
circuit reference, circuit symbol schematic designation,
When requisitioning a replacement board, the turn-in
or reference number as listed in the manufacturer's
document number of the replaced board shall be cited on
manual.
the requisition.
(5) The technical specification of the repair
5.
How to Locate Repair Parts
part as contained in the appropriate manufacturer's
manual.
a.
When NSN or reference number is
(6). The title and date of the
unknown:
manufacturer's manual from which the information in
paragraphs a, b(3), (4), and (5) above was taken.
(1) First. Using the table of contents,
determine the assembly (functional group) within which
the repair part belongs.
5
