TM 11-6625-214-12
CHAPTER 3
OPERATING INSTRUCTIONS
Section I. CONTROLS, INDICATORS, AND CONNECTORS
derive maximum use of the signal generator. These
3-1.
Scope of Procedures
items are:
A listing of all controls used by the operator is found in
a. Adjusting the output level of the signal
generator.
following items, which are individually described more
b. Step-by-step operating procedures.
completely in later paragraphs, must be thoroughly
c. Turning off the equipment.
studied in the order given and fully understood in order to
Figure 3-1. Signal Generator AN/URM-52(TS-621/U), operating controls and indicators.
3-1