INTRODUCTION
Explanation
Code
initial issues or outfittings. Not subject to
This manual lists repair parts and special tools
automatic replenishment.
required for the performance of organizational
PE-
Support equipment procured and stocked for
maintenance of the AN/URM-61 and AN/URM-61A.
The PCCN for the equipment is GTEAAT for all
tenance repair activities.
models.
PF-
Support equipment which will not be stocked
but which will be centrally procured on
This repair parts and special tools list is divided into
demand.
the following sections:
PG-
Item procured and stocked to provide for
a. Prescribed Load Allowance (PLA) - Section II.
sustained support for the life of the
Not applicable.
equipment. It is applied to an item
peculiar to the equipment which because
parts authorized for the performance of mainte-
of probable discontinuance or shutdown of
nance at the organizational level. This repair parts
production facilities would prove un-
list is arranged in alphabetical order.
economical to reproduce at a later time.
Test
support
Special
Tools,
and
c.
KD-
An item of depot overhaul/repair kit and not
Equipment - Section IV. Not applicable.
purchased separately. Depot kit defined
d. Index - Federal Stock Number and Reference
as a kit that provides items required at the
Number Cross-Reference to Figure and Item
time of overhaul or repair.
Number - Section V. A list, in ascending numerical
KF-
An item of a maintenance kit and not
sequence, of all Federal stock numbers appearing in
purchased separately. Maintenance kit
the listings, followed by a list, in alphameric
defined as a kit that provides an item that
sequence, of all reference numbers appearing in the
can be replaced at organizational or direct
listings. Federal stock number and reference num-
support or general support levels of
bers are cross-referenced to each illustration figure
maintenance.
and item number or reference designation appear-
KB-
Item included in both a depot over-
ance.
haul/repair kit and a maintenance kit.
MO-
Item to be manufactured or fabricated at
1-3. Explanation of
Columns
organizational level.
The following provides an explanation of columns in
MF-
Item to be manufactured or fabricated at
the tabular lists -
direct support maintenance level.
a. Source, Maintenance, and Recoverability Codes
MH-
Item to be manufactured or fabricated at
(SMR).
general support maintenance level.
(1) Source code. Indicates the manner of acquir-
MD-
Item to be manufactured or fabricated at
ing support items for maintenance, repair, or
depot maintenance level.
overhaul of end items. Source codes are -
AO-
Item to be assembled at organizational level.
AF-
Item to be assembled at direct support
Explanation
Code
maintenance level.
PA-
Item procured and stocked for anticipated or
AH-
Item to be assembled at general support
known usage.
maintenance level.
PB-
AD-
Item to be assembled at depot maintenance
purposes because `essentiality dictates
level.
that a minimum quantity be available in
XA-
Item is not procured or stocked because the
the supply systems.
requirements for the item will result in
the replacement of the next higher as-
P C - Item procured and stocked and which
sembly.
otherwise would be coded PA except that
XB-
Item is not procured or stocked. If not
it is deteriorative in nature.
available through salvage, requisition.
PD- Support item, excluding support equipment,
XC-
Installation drawing, diagram instruction
stocked only for subsequent or additional
2