TM 11-6625-3041-30/TO 33A1-8-908-12
2-16. POWER CABLE REPAIR (CONT)
Move adapter body and connector coupling ring back on cable
2 or 3 inches.
Use diagonal cutting pliers to cut off insulating sleeves.
All wires must be the same length. To repair a broken wire,
Female
it is necessary to unsolder all wires and cut to the same
Connector
Broken Wires length.
Temporarily tag all wires for pin connections.
Unsolder all wires from contacts.
Cut ends of wires so they are the same length.
Strip wires 3/8 in. and tin.
Cut and remove cable insulation at a point 1 3/8 in. back
from ends of wires.
Add new sleeves.
Solder wires into contacts.
Move insulating sleeves back into position over contacts.
Cut shield 7/16 in. long.
Fan shield and jumper wire and mesh together.
For assembly, see Female Connector Assembly below.
Unsolder all wires from contacts.
Female
Connector
Replace damaged or missing connector components.
Replacement
Add new sleeves.
Solder wires into contacts.
Move insulati ng sleeves back into position over contacts.
2-35