TM 11-6625-586-24P
SECTION I
INTRODUCTION
1. Scope
Definition
Code
PAItem procured and stocked for anticipated or
This manual lists spares and repair parts; special
known usage.
tools; special test, measurement, and diagnostic
equipment (TMDE), and other special support
PDSupport item, excluding support equipment,
required
for performance of
equipment
stocked only for subsequent or additional
organizational, direct support, and general support
maintenance of the AN/URM-103. It authorizes
automatic replenishment.
the requisitioning and issue of spares and repair
XDA support item that is not stocked. When
parts as indicated by the source and maintenance
required, item will be procured through
codes.
normal supply channels.
2. General
NOTE
This Repair Parts and Special Tools List is divided
Cannibalization or salvage maybe used as a
into the following sections:
source of supply for any items source coded
a. Section II. Repair Parts List. A list of spares
above except those coded XA and aircraft
and repair parts authorized for use in the per-
support items as restricted by AR 700-42.
formance of maintenance. The list also includes
(2) Maintenance code. Maintenance codes are
parts which must be removed for replacement of
assigned to indicate the levels of maintenance
the authorized parts. Parts lists are composed of
authorized to USE and REPAIR support items. The
functional groups in numeric sequence, with the
maintenance codes are entered in the third and
parts in each group listed in figure and item
fourth positions of the Uniform SMR Code format as
number sequence.
follows:
b. Section III. Special Tools List. Not ap-
(a) The maintenance code entered in the third
plicable.
position will indicate the lowest maintenance level
c. Section IV. National Stock Number and Part
authorized to remove, replace, and use the support
N u m b e r Index. A list, in National item iden-
item. The maintenance code entered in the third
tification number (NIIN) sequence, of all National
position will indicate one of the following levels of
stock numbers (NSN) appearing in the listings,
maintenance:
followed by a list, in alphameric sequence, of all
Application/Explanation
Code
part numbers appearing in the listings. National
OSupport item is removed, replaced, used at the
s t o c k numbers and part numbers are cross-
organizational level.
-referenced to each illustration figure and item
HSupport item is removed, replaced, used at the
number appearance.
general support level.
(b) The maintenance code entered in the
3. Explanation of Columns
fourth position indicates whether the item is to be
a. Illustration. This column is divided as
repaired and identifies the lowest maintenance level
follows :
with the capability to perform complete repair (i.e.,
(1) Figure number. Indicates the figure
all authorized maintenance functions). This position
number of the illustration on which the item is
will contain one of the following maintenance codes:
shown.
Application/Explanation
Code
(2) Item number. The number used to identify
HThe lowest maintenance level capable of com-
item called out in the illustration.
plete repair of the support item is the general
b. Source, Maintenance, and Recoverability
support level.
(SMR) Codes.
ZNonreparable. No repair is authorized.
(1) Source code. Source codes indicate the
(3) Recoverability code. Recoverability codes
manner of acquiring support items for main-
are assigned to support items to indicate the
tenance, repair, or overhaul of end items. Source
disposition action on unserviceable items. The
codes are entered in the first and second positions
recoverability code is entered in the fifth position of
of the Uniform SMR Code format as follows:
the Uniform SMR Code format as follows:
1