TM 11-6625-3025-14/ET426-AA-MMA-010/E154 VII210/T.O. 33A1-8-902-1-1
(2) Connect blower leads to TB-1 and tighten screws.
(3) Install rear panel described in paragraph 6-18b.
6-21. Coaxial Connector Removal and Replacement. Perform the following procedure to remove and replace any
coaxial connector (see figure 6-2).
a.
Removal. Remove coaxial connectors as follows:
(1) Remove rear panel described in paragraph 6-18a.
(2) Tag and unsolder lead(s) to connector.
(3) Remove nut and lockwasher securing connector to rear panel and remove connector.
b.
Replacement. Replace connector as follows:
(1) Insert connector into rear panel and secure with nut and lockwasher.
NOTE
Wherever shrink tubing is used, removed tubing must be replaced.
(2) Solder lead(s) to connector.
(3) Install rear panel described in paragraph 6-18b.
6-22. Terminal Board (TB-1) Removal and Replacement. Perform the following procedure to remove and replace
terminal board TB-1 (see figure 6-2).
a.
Removal. Remove terminal board TB-1 as follows:
(1) Remove rear panel described in paragraph 6-18a.
(2) Tag and disconnect all leads on terminal board.
(3) Remove two screws and lockwashers and nuts securing terminal board to rear cabinet and remove
terminal board.
b.
Replacement. Replace terminal board TB-1 as follows:
(1) Install terminal board on rear panel and secure with two screws, lockwashers and nuts.
(2) Connect all leads to terminal board and tighten screws.
(3) Install rear panel described in paragraph 6-18b.
6-14
