TM 11-6625-3051-12
(4)
Connect terminated end of BNC cable to test equipment,
(5)
Connect external trigger source to EXT TRIG IN connector (6),
(6)
Set POWER OFF/ON switch (1) to ON.
(7)
Set signal generator controls as indicated in table 2-4 (Continuous Mode Control Setup Positions),
(8)
Set FUNCTION switch (5) to desired waveform position,
(9)
Set Mode switch (2) to EXT TRIG position.
(1 O) Rotate TRIGGER LEVEL control (3) to produce triggered output.
(11 ) Adjust external trigger source frequency to change trigger interval.
Internal Gated Mode. In this mode of operation the signal generator will output a group of main generator
d.
waveforms for each gate. The modulation generator frequency is varied to provide gates of different widths and
intervals, Use the following steps to operate the signal generator in the internal gated mode.
Set POWER OFF/ON switch (1) to OFF
(1)
(2)
Connect signal generator power cable to signal generator power receptacle and to power source
Connect a 50 ohm BNC to BNC coaxial cable to the FUNCTION OUT (50 Ω) connector (6). Terminate
(3)
remaining end with a 50 ohm feedthrough load.
(4)
Connect terminated end of BNC cable to test equipment.
(5)
Set POWER OFF/ON switch (1) to ON.
2-10
