TM 11-6625-3053-14
CHAPTER 4
ORGANIZATIONAL MAINTENANCE
SECTION I. REPAIR PARTS; SPECIAL TOOLS;
TEST, MEASUREMENT AND DIAGNOSTIC EQUIPMENT (TMDE);
AND SUPPORT EQUIPMENT
4-1.
COMMON TOOLS & EQUIPMENT.
For authorized common tools and equipment refer to the Modified Table of Organization and Equip- ment (MTOE)
applicable to your unit.
4-2.
SPECIAL TOOLS, TMDE, & SUPPORT EQUIPMENT.
Refer to Section III of the Maintenance Allocation Chart (MAC) (Appendix B) for this information.
4-3.
REPAIR PARTS.
Repair parts are listed and illustrated in the Repair Parts and Special Tools List (including Depot RPSTL) TM 11-6625-
3053-24P covering maintenance for this equipment.
SECTION II. SERVICE UPON RECEIPT
4-4.
UNPACKING.
Refer to para 2-3 for unpacking (unpackaging) instructions.
4-5.
CHECKING UNPACKED EQUIPMENT.
a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report
the damage on DD Form 6, Packaging Improvement Report.
b. Check the equipment against the packing slip to see if the shipment is complete. Report all discrepancies in
accordance with the instructions of DA PAM 738-750.
c.
Check to see whether the equipment has been modified.
4-6.
BENCH INSTALLATION.
The major requirements for bench installation of this equipment are:
a.
A stable level surface on which the four feet may stand without wobbling.
b.
Proximity to a proper power source (power cord length 90 in).
4-7.
RACK INSTALLATION.
a.
Remove the four feet from the bottom of instrument.
4-1
