TM 3-1040-281-20&P
2-11. FOG OIL TANK ASSEMBLY (CONT).
a. Fog Oil Tank and Insulating Pads (Cont).
INSTALLATION (CONT)
NOTE
Reducers, valves, elbows,
adapters, and strainer assemblies
are installed the same way on both
sides of the fog oil tank except the
elbows are at different angles.
a. Install check valve (12).
b. Install reducers (11), strainer assembly (10),
valves (8), elbows (9), and adapters (6 and 7)
into fog oil tank (1).
c. Install fog oil exhaust hose (5) on adapter (7)
and fog oil inlet hose (4) on adapter (6).
d. Tighten hose clamps (3).
b. Retaining Straps and Anchor Straps.
REMOVAL/lNSTALLATION
NOTE
Removal and installation procedures
are the same for all four retaining
straps.
a. Loosen and remove nut (1), washers (2) and
spring (3) securing retaining straps (4 and 5).
b. Remove two screws (6) and key washers (7)
securing anchor strap (8) and remove retaining
strap (5) from fog oil tank assembly (9).
c. Position anchor strap (8) in retaining strap (5).
d. Position retaining strap (5) with anchor strap (8)
on fog oil tank assembly (9) and secure with
two screws (6) and key washers (7). Bend up
tab on key washers.
e. Install two washers (2), one spring (3), and
nut (1). Tighten nut (1) until retaining strap is
secure.
