TM 3-1040-281-20&P
2-13. FRAME ASSEMBLY (CONT).
c. Generator Support Rails.
REMOVAL/INSTALLATION
a. Remove front and rear support legs
b. Remove 8 screws (1), 16 washers (2),
and 8 nuts (3) securing generator sup-
port rails (4) to frame assembly (5).
c. Install generator support rails (4) on
frame assembly (5) with 8 screws (1),
16 washers (2), and 8 nuts (3).
d. Install front and rear support legs
d. ID Plate.
REMOVAL/INSTALLATION
a. Lift edge of plate with a sharp tool and pull
plate completely off mounting surface.
WARNING
Dry cleaning solvent is flammable
and toxic. Keep it away from
heat or open flames. Use in well
ventilated area. Avoid breathing
vapors.
b. Thoroughly clean mounting surface with
dry cleaning solvent. Mounting surface
must be free of all contamination such as
oil, grease, dirt, or any foreign matter.
Touch up paint as necessary (p 2-13).
c. Peel back paper from adhesive backing on
plate. Mount plate and apply pressure to
plate surface.
