(1) Pull off the knob from the lever of S1.
(3) Swing the assembly clear of the front
panel.
(2) Remove the two screws which secure this
assembly to the front panel.
(4) Unsolder the leads from the part (figs. 30
and 31). Remove and replace the part.
(3) Swing the assembly clear of the front
panel.
b. To replace the modulation switch assembly,
reverse the above procedure.
(4) Unsolder the leads; remove and replace
72. Disassembly and Assembly of DEV MULT Switch
the part (fig. 32).
Assembly
b. To replace the DEV MULT switch assembly,
a. To remove an inaccessible part on the DEV
reverse the above procedure.
MULT switch assembly (fig. 19), proceed as follows:
Figure 32. Deviation multiplier switch assembly.
52
