Section VI
Paragraphs 6-21 to 6-22
1 Six coarse frequency oscillator leads
3,4,5,6 Potentiometer panel mounting screws
2 Four ftne frequency oscillator leads
7 MICROVOLTS control shaft bushing
8 CARRIER SET control shaft bushing
repeat steps d through g until all channels operate
c. Unsolder four leads (2, figure 6-5) connected to
satisfactorily.
the terminal strip on the oscillator.
d. Remove three nuts (5, 6, 7, figure 6-6) that fas-
ten the oscillator to the tuner frame.
TOR. The fine frequency oscillator may be removed
by following the procedure outlined below.
e. Carefully slide the oscillator to the rear and off
the shaft and then out the top of the r-f section.
a. Remove the top and bottom covers from the r-f
chassis.
f. Note, or record by sketching, the orientation of
the slot in the rotor of the wafer switch in the oscil-
b. Remove the fine frequency oscillator tube, V1501,
later. Also note or record the setting of the MEGA-
and its shield.
CYCLES control on the front panel.
