TM 11-6625-3041-30/TO 33A1-8-908-12
2-12. KNOB REPLACEMENT
Both the TIMING and DATA RATE knobs are replaceable.
Tools and
TK-101/G Tool Kit , Electronic Equipment for:
Materials
Required
0.050-in. hex wrench
Primer (item 1, Appendix B).
Sealing compound (item 2, Appendix B).
Removal
Note position at
which knob is set.
Use 0.050-in. hex
wrench to loosen
the two set screws
in the knob.
Remove knob.
Use 0.050-in. hex
wrench to remove
the two set screws
from the new knob.
Apply a drop of
primer to each set
screw.
Apply a drop of
sealing compound to
each set screw.
Use 0.050-in. hex wrench to reinstall the set screws in the
new knob.
Install new knob on shaft in same position as knob that was
removed.
Use 0.050-in. hex wrench to tighten the two set screws that
secure knob to shaft.
