Figure 23. Mounting plate.
(1)
Position the assembly and secure it to the
connections allows ample room
to
mounting plate with four screws.
continue the removal of C44.
(2)
Solder the three leads attached to R42, R44,
(3) Unsolder the three leads to C45, C46 (fig.
and R46 (fig. 22).
(3)
Replace the rf assembly as described in
(4) Remove the seven screws (fig. 23) which
hold the capacitor in place.
(5) Remove the assembly.
64. Disassembly and Assembly of Capacitor
Note
Assembly C44
The split gears, L20 and R68, are
components of tuning capacitor
assembly C44 (fig. 25).
b. To replace tuning capacitor assembly C44,
accomplished by removing the long screw
proceed as follows:
which passes through the center of RT2 and
which secures it to the rf assembly, and by
(1) Position and secure the capacitor in place
unsoldering the two leads coming off RT2.
with the seven screws.
(2) Solder the three leads to C45, C46, and
(2) Free the modulator chassis (V10 and V11
C41.
are mounted on this chassis; see fig. 25) by
(3) Position, then secure the modulator chassis
removing the six screws (fig. 21) which
to the rf assembly with six screws.
secure it to the rf assembly.
(4) Position RT2. Replace the long screw which
Note
secures RT2 to the rf assembly. Solder the
Do not unsolder any connections. The
two leads.
chassis will lift freely and the length of
46
