TM
3-1040-281-20&P
a. Apply a layer of plastic strip (10) to fog oil tank assembly mounting surface on frame assembly (15) (p2-4).
Cut out six mounting holes in plastic strip with knife.
b. Position fog oil tank (6) on frame assembly with fuel cap (17) to rear of vehicle. Secure fog oil tank assembly
with 6 screws (12), 12 washers (13), and 6 nuts (14).
NOTE
Reducers, valves, elbows, adapters, and
strainer are installed the same way on both
sides of the fog oil tank except that elbows are
at different angles. Discard parts removed.
a. Remove adapter (18) and cap from fog oil tank and
install check valve (11).
b. Remove protective plug (19) and install reducer (7),
ball valve (9), elbow (10), and adapter (5) in fog oil
tank supply port.
c. Remove protective plug (20) and install reducer (7),
strainer assembly (8), elbow (10), ball valve (9), and
adapter (4) in fog oil tank supply port.
d. Install cage mount assembly and smoke generator
e. Reconnect fog oil inlet hose (2) to fog oil tank sup
ply adapter (4). Reconnect fog oil exhaust hose (3)
to fog oil tank return adapter (5). Tighten fog oil
hose damps (1).